User's Manual

UE910 V2 Hardware User Guide
1VV0301065 Rev.1 – 2013-12-12
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 54 of 67
12.3. Recommended foot print for the application
144 pins
< Top View >
In order to easily rework the UE910 V2 it is suggested to consider having a 1.5 mm placement inhibit
area around the module on the application.
It is also suggested, as a common rule for an SMT component, to avoid having a mechanical part of
the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see figure) must be clear from
signal or ground paths.