User's Manual

UE910 V2 Hardware User Guide
1VV0301065 Rev.1 – 2013-12-12
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 49 of 67
10.3. Using a GPIO Pad as Output
The GPIO pads, when used as outputs, can drive 1.8V CMOS digital devices or compatible hardware.
When set as outputs, the pads have a push-pull output and therefore the pull-up resistor may be
omitted.
10.4. Indication of Network Service Availability
The STAT_LED pin status shows information on the network service availability and Call status. In
the UE910 V2 modules, the STAT_LED usually needs an external transistor to drive an external LED.
Because of the above, the status indicated in the following table is reversed with respect to the pin
status:
LED status
Device Status
Permanently off
Device off
Fast blinking
(Period 1s, Ton 0,5s)
Net search / Not registered / turning off
Slow blinking
(Period 3s, Ton 0,3s)
Registered full service
Permanently on
a call is active
A schematic example could be: