User's Guide

UC864-E-AUTO / AWS-AUTO Hardware User Guide
1vv0300795 Rev.11 – 2010/11/18
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 60 of 78
12.9. Using the Temperature Monitor Function
12.9.1. Short Description
The Temperature Monitor is a function of the module that permits to control its
internal temperature and if properly set (see the #TEMPMON command on AT
Interface guide) it raises to High Logic level a GPIO when the maximum temperature
is reached.
12.9.2. Allowed GPIO
The AT#TEMPMON set command could be used with one of the following GPIO:
Signal
SignalSignal
Signal Function
FunctionFunction
Function Type
TypeType
Type
Drive
Drive Drive
Drive
strength
strengthstrength
strength
Note
NoteNote
Note
GPIO_01 GPIO01 Configurable GPIO CMOS 2.6V 2mA
GPIO_03 GPIO03 Configurable GPIO CMOS 2.6V 2mA
GPIO_08 GPIO08 Configurable GPIO CMOS 2.6V 2mA
GPIO_09 GPIO09 Configurable GPIO CMOS 2.6V 2mA
GPIO_10 GPIO10 Configurable GPIO CMOS 2.6V 2mA
GPIO_11 GPIO11 Configurable GPIO CMOS 2.6V 2mA
GPIO_12 GPIO12 Configurable GPIO CMOS 2.6V 2mA
GPIO_13 GPIO13 Configurable GPIO CMOS 2.6V 2mA
GPIO_14 GPIO14 Configurable GPIO CMOS 2.6V 2mA
GPIO_15 GPIO15 Configurable GPIO CMOS 2.6V 2mA
GPIO_16 GPIO16 Configurable GPIO CMOS 2.6V 2mA
GPIO_17 GPIO17 Configurable GPIO CMOS 2.6V 2mA
GPIO_18 GPIO18 Configurable GPIO CMOS 2.6V 2mA
GPIO_19 GPIO19 Configurable GPIO CMOS 2.6V 2mA
GPIO_20 GPIO20 Configurable GPIO CMOS 2.6V 2mA
GPIO_22 GPIO22 Configurable GPIO
CMOS 1.8V (not
2.6V)
2mA