Manualshelf

User's Guide

ManualsBrandsTelit Communications ManualsElectronicsGSM 850, E-GSM 900, DCS 1800, PCS 1900, FDD IV, 2G/3.5G module
11121314151617181920
UC864-E-AUTO / AWS-AUTO Hardware User Guide
1vv0300795 Rev.11 – 2010/11/18
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 18 of 78
5.3.1. Shutdown by Software Command
UC864-E-AUTO / AWS-AUTO can be shut down by a software command.
When a shut down command is sent, UC864-E-AUTO / AWS-AUTO goes into the
finalization state and finally will shut down PWRMON at the end of this state.
The period of the finalization state can differ according to the situation in which the
UC864-E-AUTO / AWS-AUTO is so it cannot be fixed definitely.
Normally it will be above 10 seconds later from sending a shut down command and
DTE should monitor the status of PWRMON to see the actual power off.
TIP:
TIP: TIP:
TIP:
To check if the device has powered off, hardware line PWRMON must be monitored.
When PWRMON goes low, the device has powered off.