User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 96 of 202
5.4.4 Mobile Equipment control
5.4.4.1 +CPAS - phone activity status
+CPAS – phone activity status
Execute command
AT+CPAS
reports the device status in the form
+CPAS: <pas>
where
<pas> - phone activity status
0 - ready (Device allows commands from TA/TE)
1 - unavailable (Device does not allow commands from TA/TE)
2 - unknown (Device is not guaranteed to respond to instructions)
3 - ringing (Device is ready for commands from TA/TE, but the ringer is active)
4 - call in progress (Device is ready for commands from TA/TE, but a call is in
progress)
Read command
AT+CPAS?
same as Execute command.
Write command
Test command
AT+CPAS=?
Reports the supported range of values of <pas>.
Example ATD03282131321;
OK
AT+CPAS?
+CPAS: 3 (the called phone is ringing)
OK
AT+CPAS?
+CPAS: 3
OK
AT+CPAS?
+CPAS: 4 (the called phone has answered to your call)
OK
ATH
OK
Reference GSM 07.07
SW release
Version A
5.4.4.2 +CFUN Set phone functionality (Power Saving Management)
+CFUN – power saving management
Execute command
Read command
AT+CFUN?
reports the power saving status in the form:
+CFUN: <fun>
where
<fun> - power saving status
1 - power saving disabled
5 - power saving enabled