User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 86 of 202
5.4.3.7 +CLIR - calling line identification restriction
+CLIR – calling line identification restriction
Execute command
Read command
AT+CLIR?
Reports the network & the device CLIR setting in the format:
+CLIR:<n>,<m>
where
<n> is the facility status on the Mobile
0 – CLIR facility according to CLIR service network status
1 – CLIR facility active (CLI not sent)
2 – CLIR facility not active (CLI sent)
<m> is the facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
Write command
AT+CLIR = <n>,<m>
Refers to CLIR – service that allows a calling subscriber to enable or disable the presentation
of the CLI to the called party when originating a call according to the parameters <n> and
<m> given
Parameters: <n>, <m>
<n> is the facility status on the Mobile
0 – CLIR facility according to CLIR service network status
1 – CLIR facility active (CLI not sent)
2 – CLIR facility not active (CLI sent)
<m> is the facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
Note: This command set the default behaviour of the device in outgoing calls and of the
network. The two settings should not be conflicting.
Test command
AT+CLIR=?
Reports the supported values of the parameter <n>.
Example
Reference GSM 07.07
SW release Version A