User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 48 of 202
5.3.2.3 V- result code form
V – result code form
Execute command
Read command
Write command
ATV <n>
Sets the result code format.
Parameter:
<n> = 0 set the short format (terse) return codes are numbers 0-9.
<n> = 1 set the long form (verbose) return codes.
Note: Line feed is not issued before a short format result code.
Test command
Example
Reference V25ter
SW release Version A
5.3.2.4 X - extended result codes
X – extended result codes
Execute command
Read command
Write command
ATX <n>
Selects the result code messages subset used by the modem to inform the DTE of the result
of the commands.
Parameter:
<n> = 0 - send only OK, CONNECT, RING, NO CARRIER, ERROR, NO ANSWER
results. Busy tones reporting is disabled.
<n> = 1,2,3,4 - reports all messages (default).
Test command
Note For complete control on CONNECT response message see also +DR command.
Reference V25ter
SW release Version A