User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 47 of 202
5.3.2 DTE - modem interface control
5.3.2.1 E - command echo
E – command echo
Execute command
Read command
Write command
ATE <n>
Controls the command echo response of the device, enabling or disabling the echo.
Parameter:
<n> = 0 - disables command echo, hence after this command the only characters received
by DTE are the responses to commands sent to device.
<n> = 1 - enables command echo (default) , hence command sent to the device are echoed
back to the DTE before the response is given.
Test command
Example
Reference V25ter
SW release Version A
5.3.2.2 Q - quiet resut codes
Q – quiet result codes
Execute command
Read command
Write command
ATQ <n>
Enables or disables the result codes.
Parameter:
<n> = 0 - enables result codes
<n> = 1 - disables result codes
Note: After disabling result codes with ATQ1, the device does not return a response to
commands (usually OK), but command are executed anyway.
Test command
Example
Reference V25ter
SW release Version A