User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 43 of 202
5.3.1.13 &V - display current configuration & profile
&V – display current configuration & profile
Execute command
AT&V
Returns all the configuration parameters settings.
Read command
Write command
Test command
Example AT&V
DTE SPEED : 19200
DTE FORMAT : 8N1
CELLULAR PHONE : GSM TELIT: Operative
GSM DATA MODE : \N4=Not Trasparent
AUTOBAUD : +IPR0=YES
COMMAND ECHO : E1=YES
RESULT MESSAGES : Q0=YES
VERBOSE MESSAGES : V1=YES
EXTENDED MESSAGES : X1=YES
ECM TYPE MESSAGES : \V0=NO
LINE SPEED : F8=9600
CONSTANT DTE SPEED : \J0=YES
FLOW CONTROL OPTIONS : &K3=HW bidirect.
ERROR CORRECTION MODE : \N4=RLP
CTS (C106) OPTIONS : &B2=OFF while disc.
DSR (C107) OPTIONS : &S3=PHONE ready->ON
DTR (C108) OPTIONS : &D0=ignored
DCD (C109) OPTIONS : &C1=follows carrier
RI (C125) OPTIONS : \R1=OFF dur. off-hk
C108/1 OPERATION : &D4=NO
POWER SAVING ON DTR : +CFUN:1=NO
CALL ABORT : YES
DEFAULT PROFILE : &Y0=user profile 1
OK
Reference V25ter
SW release Version A
5.3.1.14 &V0 - display current configuration & profile
&V0 – display current configuration & profile
Execute command
AT&V0
Returns all the configuration parameters settings.
Note: this command is the same as &V, it is included only for backwards
compatibility.
Read command
Write command
Test command
Example
Reference
SW release Version A
5.3.1.15 &V1 - display S registers values
&V1 – display S registers values
Execute command
AT&V1
Returns the value of the S registers in decimal and hexadecimal value in the format: