User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 39 of 202
5.3.1.3 +FCLASS - select active service class
+FCLASS - select active service class
Execute command
Read command
AT+FCLASS?
Returns the current configuration value of the parameter <n>.
Write command
AT+FCLASS= <n>
Set the TRIZIUM in specified connection mode (data, fax, voice), hence all the calls done
after, will be data or voice.
Parameter:
<n>: 0 = data
<n>: 1 = fax class 1
<n>: 8 = voice
Test command
AT+FCLASS=?
Returns all supported values of the parameters <n>.
Example
Reference GSM 07.07
SW release Version A
5.3.1.4 &Y - designate a default reset profile
&Y – designate a default reset profile
Execute command
AT&Y <n>
The TRIZIUM is able to store 2 complete configurations (see command &W). The
command &Y defines which one of the 2 profiles will be the default profile to be loaded on
startup.
Parameter: <n> = 0…1 - profile
Note: Differently from ATZ<n> command which simply loads the desired profile , with the
command AT&Y the chosen profile becomes the one which will be loaded on every startup.
Read command
Write command
Test command
Example
Reference
SW release Version A
5.3.1.5 &W - store current configuration
&W – store current configuration
Execute command
AT&W <n>
Stores on profile n the complete configuration of the device.
Parameter: <n> = 0…1 - profile
Read command
Write command
Test command
Example
Reference
SW release Version A