User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 196 of 202
6 Conformity Assessment Issues
The Telit TRIZIUM module is assessed to be conform to the R&TTE Directive as stand-alone product, so If the
module is installed in conformance with Dai Telecom installation instructions require no further evaluation under
Article 3.2 of the R&TTE Directive and do not require further involvement of a R&TTE Directive Notified Body for the final
product.
In all other cases, or if the manufacturer of the final product is in doubt then the equipment integrating the radio module
must be assessed against Article 3.2 of the R&TTE Directive.
In all cases assessment of the final product must be made against the Essential requirements of the R&TTE Directive
Articles 3.1(a) and (b), safety and EMC respectively, and any relevant Article 3.3 requirements.
The Telit TRIZIUM module is conform with the following European Union Directives:
¨ R&TTE Directive 1999/5/EC (Radio Equipment & Telecommunications Terminal Equipments)
¨ Low Voltage Directive 73/23/EEC and product safety
¨ Directive 89/336/EEC for conformity for EMC
In order to satisfy the essential requisite of the R&TTE 99/5/EC directive, the TRIZIUM module is
compliant with the following standards:
• GSM (Radio Spectrum). Standard: EN 301 511 and 3GPP 51.010-1
• EMC (Electromagnetic Compatibility). Standards: EN 301 489-1 and EN 301 489-7
• LVD (Low Voltage Directive) Standards: EN 60 950
Furthermore the Telit TRIZIUM module is FCC Approved as module to be installed in other devices. This
device is to be used only for fixed and mobile applications. If the final product after integration is intended
for portable use, a new application and FCC ID is required.
The Telit TRIZIUM module is conform with the following US Directives:
¨ Use of RF Spectrum. Standards: FCC 47 Part 24 (GSM 1900)
¨ EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
To meet the FCC's RF exposure rules and regulations:
- The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all the persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
- The antenna(s) used for this module must not exceed 3 dBi for mobile and fixed or mobile operating
configurations.
- Users and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any
regulatory questions and to have their complete product tested and approved for FCC compliance.
Interference statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.