User's Manual

Telit TRIZIUM Product Description

80264ST10007a Rev. 4– 09/09/04

has occurred.

3 - the TRIZIUM will make both the actions as for mode=1 and mode=2.

4 - the Jammed Detect is active and the Jammed condition is reported with an

unsolicited code every 3s on serial line, whose format is:

#JDR: JAMMED - Jammed condition detected

#JDR: OPERATIVE - Normal Operating condition restored.

Note: the #JDR: OPERATIVE code will show only once and after a jammed

condition has occurred.

5 - the TRIZIUM will make both the actions as for mode=1 and mode=4.

10 -The TRIZIUM will Report the Jammed status to the network on Jammed

Detection.

11 - the TRIZIUM will make both the actions as for mode=10 and mode=1.

12 - the TRIZIUM will make both the actions as for mode=10 and mode=2.

13 - the TRIZIUM will make both the actions as for mode=10 and mode=3.

14 - the TRIZIUM will make both the actions as for mode=10 and mode=4.

15 - the TRIZIUM will make both the actions as for mode=10 and mode=5.

<MNPL> - Maximum Noise power Level

0 -127

<DCMN> - Disturbed Channel minimum number

0 - 254

Note: The values 10 - 15 of mode parameter will be available on future sw release.

Test command AT#JDR=?

Reports the supported range of values for the parameters <mode>,<MNPL>,

<DCMN>

Example

AT#JDR=2

… jammer enters in the range…

#JDR: JAMMED

… jammer exits the range…

#JDR: OPERATIVE

Reference Telit Specifications.

SW release

Version B