User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 180 of 202
5.9.1.3 #TPHOTO – Camera Take Photo
#TPHOTO – Camera Take Photo Command
Execute command
AT#TPHOTO
Commands the CAMERA to take the photo and stores it in the TRIZIUM memory.
Read command
Write command
Test command
NOTE The photo is kept in the TRIZIUM RAM memory, therefore after a power off it is
lost.
There's only 1 position for the photo, every photo will overwrite the previous.
The photo is taken during IDLE time, if the mobile is busy on network operations,
(e.g. during a call) the photo cannot be taken.
Example AT#TPHOTO
OK
… the camera has taken the photo and it is now stored on the TRIZIUM memory.
Reference
Telit specifications
SW release
Version A
5.9.1.4 #RPHOTO – Camera Read Photo
#RPHOTO – Camera Read Photo Command
Execute command
AT#RPHOTO
After this command the TRIZIUM starts to flush the photo in its memory to the serial
line, ending it with the Ok code..
Read command
Write command
Test command
NOTE The photo is flushed as hexadecimal characters in the format selected.
Example AT#RPHOTO
xxxxxxxxxxxx (binary digits of the JPEG image)
<cr><lf>OK<cr><lf>
… the photo has been flushed to the serial line.
Reference
Telit specifications
SW release
Version A