User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 154 of 202
5.6.1.18 #MONI – Monitor Cells
#MONI – monitor cell
Execute command
AT#MONI
Reports the available data for cell and dedicated channel (if exists) in the format:
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm
or in the case the network name is not known:
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id>
ARFCN:<arfcn> PWR:<dBm> dBm
or in the case in which the data of the adjacent cell are under observation
(number>0):
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn> PWR:<dBm> dBm
where:
netname = name of network operator
cc = country code
nc = network operator code
n = progressive number of adjacent cell
bsic = base station identification code
qual = quality of reception (0-7)
lac = localization area code
id = cell identifier
arfcn = assigned radio channel
dBm = received signal strength in dBm
Read command
Write command
AT#MONI =<number>
Set the neighbor cell to extract data of the cell number <number>
Parameter: <number>
Test command AT#MONI=?
Reports the available neighbour cells and current cell preset in the format: #MONI:
<CellNo, CellSet>
where:
<CellNo> - neighbour cells number
<CellSet> - cell preset = 0, …, n where 0 is the serving cell
Example
Note The refresh time of the measures is preset to 3 sec
Reference Telit TRIZIUM AT Command Specification
SW release Version A
5.6.1.19 #QSS – Query SIM Status
#QSS – query SIM status
Execute command
Read command
AT#QSS?
Reports the query SIM status in the format:
#QSS: <mode>,<status>
where
<mode>: type of enabled notification
<mode> = 0 - query only
<mode> = 1 - send unsolicited indication (#USS) every change of state
<status>: current SIM status
<status> = 0 - SIM NOT INSERTED
<status> =1 - SIM INSERTED
Write command