User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 148 of 202
5.6.1.13 #QTEMP –Query Temperature overflow
#QTEMP – query temperature overflow
Execute command
Read command
AT#QTEMP?
Queries the internal temperature sensor of the device for over temperature. The result
is reported in the format:
#QTEMP:<temp>
where
<temp> - over temperature indicator
<temp> = 0 - device temperature is in the working range
<temp> = 1- device temperature is out of the working range, may be too high or too
low.
Note: The device should not be operated out of its working temperature range; if
temperature is out of range proper functioning of the device is not ensured.
Write command
AT#QTEMP = <mode>
Sets the type of indication.
Parameter:
<mode> - type of indication
0 - result reported only when querying with #QTEMP?
1 - reserved for future use
2 – reserved for future use
Test command
#QTEMP=?
Reports supported range of values for <mode> parameter.
Example
Reference Telit TRIZIUM AT Command Specification
SW release
Version A