User's Manual

Telit TRIZIUM Product Description

80264ST10007a Rev. 4– 09/09/04

5.6.1.12 #WAKE – Wake from Alarm mode

#WAKE – Wake from Alarm Mode

Execute command

AT#WAKE=0

After the issuing of this command device exits the "Alarm mode" and enters the

normal operating mode. After entering in normal operating mode an OK response is

returned.

With the execution of is command all Alarm activity (for example alarm tone

playing ) is immediately terminated.

If the command is issued during the normal operating mode then the only action is

to stop Alarm activity, if present, and return OK response.

Read command

AT#WAKE?

This command returns the operating mode status of the device in the format:

#WAKE: <status>

where:

<status> - operating mode

0 - normal operating mode

1 - alarm mode

Note: The "alarm mode" is indicated by hardware pin CTS to the ON status and

DSR to the OFF status, while the "power saving" status is indicated by a CTS -

OFF and DSR - OFF status. The normal operating status is indicated by DSR - ON.

During the "alarm mode" the device will not make any network scan and will not

the only commands that can be issued to the TRIZIUM in this state are the #WAKE

and #SHDN, every other command must not be issued during this state.

Write command

Test command

Example

Reference Telit TRIZIUM AT Command Specification

SW release

Version A