User's Manual

Telit TRIZIUM Product Description
80264ST10007a Rev. 4– 09/09/04
Reproduction forbidden without DAI Telecom written authorization – All Right reserved – Right of modification reserved page 129 of 202
5.5.2 Message configuration
5.5.2.1 +CSCA - service center address
+CSCA –service center address
Execute command
Read command AT+CSCA?
Reports the current value of the default SCA in the format:
+CSCA: <number>,<type>
Note: if SCA is not present the device reports an error message.
Write command
AT+CSCA=<number>,
<type>
Sets the Service center Address to be used for mobile originated SMS
transmissions.
Parameter:
<number> - SC phone number in the format defined by <type>
<type> - the type of number
<type> = 145 - international numbering scheme (contains the character "+")
<type> = 129 - national numbering scheme
Note: to use the SMS service, is mandatory to set a Service Center Address at which
service requests will be directed. SCA depends on the operator, hence contact your
operator to set the right SCA. When this address is input, it is stored on the SIM if
possible, else will be stored on the device internal memory so, once set, the input of
this parameter is not anymore needed.
In PDU mode, this setting is used, but only when the length of the SMSC address
coded into the <pdu> parameter equals zero; else SCA defined in the PDU will be
used instead.
Test command
Example
Reference GSM 07.05
SW release
Version A