User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
49 | P a g e
12.4 Cell modem Commands
The APS-NR2 uses a Telit H24 cell modem.
Specific commands for the cell modem are described in H24 AT Commands Reference
Guide 80389ST10086a Rev.4 – 2013-02-19.
The Web Interface or the data collection software accompanying the product uses these
commands to configure the modem.
It is not advised for the user to issue commands to the modem using e.g. the expert
console.
Issuing commands to the cell modem using the Expert Console may cause malfunctioning of the device
and will be considered improper use.