User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
47 | P a g e
12.2 Front Panel LEDs
NO BATTERY
BATTERY
BLINKING
NOT IN USE
SOLIDLY LIT
IN USE
LESS THAN 5% REMAINING
LESS THAN 20% REMAINING
OK
OFF
BLUETOOTH
BLINKING
RADIO ON/DISCOVERABLE
CONNECTED
OFF
WIFI
ON
OFF
MODEM
CONNECTING
CONNECTED
NO POSITION CALCULATED
POSITION
FIXED POSITION
SBAS, DGPS, FLOAT
STAND ALONE
RECEIVING
CORRECTIONS
NOT RECEIVING
DISABLED
LOGGING
LOGGING
BLINKING SLOWLY
LOGGING
DISK > 80% FULL
BLINKING FAST
LOGGING
DISK FULL OR NOT MOUNTED