User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
46 | P a g e
12 Appendix
12.1 Status Icons on the Web Interface
The icons on the right hand side of the top banner quickly show the user the status of
the APS-NR2.
Position mode
The APS-NR2 will function in modes of increasing accuracy, depending on the
configuration.
Cellular Status
Off
On, showing signal quality
Wi-Fi
Off
On
Bluetooth
Off
On
Battery
No battery
Empty
Charging
In use
Corrections
No Corrections received
Corrections being received
Logging
Off
Logging
Disk full or not
mounted
Figure 35: Web Interface Status Icons