User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
44 | P a g e
11.1.4 Expert Console
Line commands can be sent to the APS-NR2 via the Expert Console menu.
The drop down box showing "Mainboard (APS-NR2)" in Figure 33 allows selecting the
APS-NR2's sub system the commands will be directed to.
The sub systems of the APS-NR2 are the Mainboard (APS-NR2), GNSS Receiver and the
Cell modem.
Responses will be shown the window below the label Expert Console.
Specific messages may be viewed via the Message Inspector, shown near the bottom of
the tab.
The command set of the APS-NR2 is described in the document named Command Line
Interface Reference Guide.pdf.
Changing the APS-NR's configuration using the Expert Console may cause the device to malfunction.
Figure 33: Web Interface Admin-Expert Console