User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
42 | P a g e
11.1.2 Reset
1. Click The tab.
2. Select the Reset Option.
Figure 31: Admin - Reset
3. Select the desired reset level using Table 8 and Table 9.
4. Click OK
5. The APS-NR2 restarts.
Level
Description
Soft
This is a reset of the receiver's firmware.
The receiver will restart operating in the same configuration as
before the command was issued, unless Config has been ticked.
Hard
This is similar to a power off/on sequence.
After hardware reset, the receiver will copy the Boot configuration
into the Current configuration..
Upgrade
Set the receiver into upgrade mode. After a few seconds, the
receiver is ready to accept an upgrade file (SUF format) from any of
its connections.
Table 8: APS-NR2 Reset Levels
Erase
Description
Config
The RxDefault configuration is copied into the receiver's Boot and
Current configurations.
The User1 and User2 configurations remain unchanged.
Bluetooth
All information about previously paired devices is cleared.
Table 9: APS-NR2 Reset- Memory Erase Options