User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
40 | P a g e
The table below gives an overview of the APS-NR2s configurations.
Configuration
Persistent?
Writable?
Description
RxDefault
Yes
No
Contains the factory default.
Current
No
Yes
Settings that are actually being used.
Boot
Yes
Yes
The values of Boot are copied into Current at
start up.
User1, User 2
Yes
Yes
Two configurations can be stored for later
use.
Table 6: APS-NR2 Configurations
The Web Interface provides the following operations on configurations:
Copy
The Copy operation allows the user to copy any of the five
configurations into another configuration.
Download
The Download operation allows the user to export a selected
configuration to a text file.
Upload
The Upload operation allows the user to import a selected
configuration from a text file.
Table 7: APS-NR2 Operations on configurations
11.1.1.2 Managing Configurations
The APS-NR2's configurations can be managed from the Admin tab.
1. Click the tab.
2. Select Configurations.
The Configurations tab will resemble Figure 29.
Figure 29: Web Interface Admin-Configurations