User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
37 | P a g e
10 Hot Swapping the batteries and charging
10.1 Battery Swapping
Both the Web Interface and front panel LEDS give information about the battery status.
NO BATTERY
Insert a charged battery
BATTERY
BLINKING
LESS THAN 5% REMAINING
IN USE
Replace the battery!
BLINKING
LESS THAN 20% REMAINING
IN USE
BLINKING
OK
IN USE
No action needed,
but battery can be replaced.
Table 4: Battery not in use
SOLIDLY LIT
LESS THAN 5% REMAINING
IN USE
Do not open the battery cover!
BATTERY
SOLIDY LIT
LESS THAN 20% REMAINING
IN USE
SOLIDLY LIT
OK
IN USE
Table 5: Battery in use
When both batteries are below 5% then the APS-NR2 will make use of both batteries.
The user may replace either battery without interrupting operation.