User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
33 | P a g e
4. Click the OK button shown in Figure 25
Figure 25: OK to execute the copy
8.2 Switch off Wi-Fi
The nominal battery lifetime of a full working day can only be improved if Wi-Fi is
switched on only during configuration.
Therefore the user is advised to switch off Wi-Fi after the configuration is completed.
The user can switch off Wi-Fi by clicking the power button twice as described in section
"3.2 Power Button Functions" on page 14 or by clicking the on/off toggle button in the
Overview tab of the Web Interface as shown in Figure 26.
Figure 26: Wi-Fi On/Off toggle button in the Overview tab