User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
32 | P a g e
8 Finalizing the configuration
8.1 Make the settings persistent
If the user has consistently pressed Save when the pop up shown below has appeared
on the screen, all settings will be persistent and will be applied again when the device
powered on.
Figure 22: Save to Boot pop up
If the user is not sure all settings have been stored, the procedure below is to be
executed.
1. Click on the tab
2. Select Current in the Source drop down box as shown in Figure 23.
Figure 23: Select Current as Source
3. Select Boot in the Target drop down box as shown in Figure 24
Figure 24: Select Boot as Target