User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
31 | P a g e
7 Set the Antenna Height
The antenna height is the offset between the measured point and the Antenna Reference Point.
Practically this is the height of the survey rod.
The APS-NR2 automatically compensates for the Antenna Phase Center.
1. Click on the tab and enter in an antenna height.
2. Click Apply when finished.
In this example, 2 meters was used.
Figure 21: GNSS Tab : setting Antenna Offset