User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
30 | P a g e
6.3.2 Advanced Settings for Logging
Typically the Advanced Settings for Logging are not reconfigured by the user.
So this section may be skipped during the initial configuration.
The Advanced settings for logging are elaborated in APS-NR2 Firmware Command Line
Interface Reference Guide.
The "Disk Full Action" and "SBF and NMEA File Naming Conventions" are elaborated in
the section "Logging Commands"
The Marker Parameters are elaborated in the section "Session Settings Commands"
1. Click on the tab
2. Click on Advanced Settings.
Advanced settings allow for a filename and marker name to be specified.
Figure 20: Web Interface Logging - Advanced Settings