User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
29 | P a g e
6.3 Activate Logging
6.3.1 Basic Configuration of Logging
The Logging functionality allows data to be stored on the APS-NR2's internal disk.
This disk has a capacity of 8GB.
The user may select SBF blocks (Septentrio Binary Format) and/or NMEA messages
(National Marine Electronics Association) to be logged.
Data logged can be downloaded in the File Explorer menu by clicking the green arrow in
the Download column.
The downloaded file will be in the browser’s download directory.
Figure 19: Logging Tab
1. Click on the tab.
2. Check the required SBF blocks and NMEA messages.
3. Select the logging interval.
4. Activate the logging by setting Logging to on.
5. Click OK to apply the settings.