User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
28 | P a g e
6.2 Configure the NMEA for Bluetooth output
The tab allows the user to view paired Bluetooth devices and start/stop
NMEA.
1. Click the tab on the APS-NR2's Web Interface
2. Select the required NMEA messages and the required Interval
3. Make sure the Output is set to On
4. Click OK
Figure 18: Web Interface NMEA