User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
24 | P a g e
5.2 Configure as NTRIP client
1. Make sure you have a cellular connection as described in the previous section.
2. Select the tab on the APS-NR2's Web Interface.
Figure 13:NTRIP tab of the Web Interface
3. Select 'Client' in the Mode drop down box.
4. Enter the Caster server name or IP address and the Port of your CORS.
5. Enter the User Name and Password of your account.
The NTRIP password will automatically be encrypted and not shown for security.
6. Once the NTRIP Mode, Caster, and Port are entered, the Mount Point drop down
box will be populated.
Figure 14: NTRIP Settings
7. Select a Mount Point in the drop down box.
8. Click OK
9. The APS-NR2 will automatically initialize and connect.