User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
22 | P a g e
5.1 Set up the cellular modem
1. Click the tab on the Web Interface to show the status of the Cell Modem.
2. Enter a Cellular PIN, APN, Username and Password from this tab.
3. Make sure the 'on' radio buttons of both Power and Connect are selected.
4. Click OK
Figure 10: Cellular Status : Cell disabled
If the connection has been established successfully, the Status will change from
InitializingConnectingConnected as shown in Figure 11 and Figure 12.
The line on the left hand will turn green and indicate the connection type (e.g. HSPA) and Status fields
on the bottom right of the page will be filled as shown in Figure 10.
Figure 11: Cellular Status: Getting connected