User's Manual

Table Of Contents
21 | P a g e
5 Basic Configuration of the APS-NR2 for RTK
After successfully executing the steps in "Initial set up", your APS-NR2 is ready to be
configured to receive corrections and output position data.
After each change made to the APS-NR2's configuration while executing the steps in the
following sections the pop up will appear in the bottom right of the browser window.
If the user clicks Save, the settings are stored in the boot configuration and will be
applied again when the APS-NR2 is restarted.
The configuration mechanism is explained in detail in section "11.1.1 Configuration" on
page 39.
Figure 9: Save to Boot pop up