User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
18 | P a g e
4 Initial set up
4.1 Prerequisites
An Activated Micro SIM Card
In some countries a PIN and PUK code are required to use the card.
If so, make sure you have the codes at hand.
To establish a data connection an Access Point Name (APN), user name and
password are needed. If you do not have this information, you need to request it
from the telecom provider.
An active RTK (NTRIP or TCP/IP) service
A subscription for a (NTRIP or TCP/IP) correction service.
Charged Batteries
Make sure you have two charged batteries.
Empty batteries may take three to four hours to charge.
A APS-NR2 Wall Charger
As an alternative you can power the APS-NR2 using the wall charger when
configuring the APS-NR2.
A phone, tablet or computer with a Wi-Fi radio
A Wi-Fi enabled device is needed to configure the APS-NR2 using the Web
Interface.