User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
13 | P a g e
3 APS-NR2 Overview
This section will guide the user through the main parts of the APS-NR2. The detailed
steps how to configure the APS-NR2 will be elaborated in later sections.
3.1 Front Panel
The APS-NR2 has an intuitive front panel with status LEDs and the power button.
Figure 2: APS-NR2 Front Panel
The table below provides a brief overview of the LED indications.
A complete table is provided in section "12.2 Front Panel LEDs" on page 47.
Function
Indication
Battery Power Level
Battery Power level (Green to Red)
solidly lit = battery is in use, blinking = battery is not in use
Bluetooth (not) paired
Bluetooth is off (not lit), connecting (blinking), Paired (blue)
Wi-Fi On/Off
Wi-Fi On (Green) or Off (not lit)
Cellular Modem Status
The modem is not in use (not lit), connecting (orange), connected
(green) or there is an error in the connection (red)
Position Mode
The reported position is “RTK Fixed” (green), Stand alone (red), any
other mode (orange) or no position can be calculated (not lit)
Differential Corrections
Differential Corrections are being received (Green) or
differential Corrections are not being received (not lit)
Data Logging
Logging is disabled (not lit), active (green)
Table 3: APS-NR2 : Front LED – Short