User's Manual
Table Of Contents
- 1 Introduction
- 2 Shipping Case Contents
- 3 APS-NR2 Overview
- 4 Initial set up
- 5 Basic Configuration of the APS-NR2 for RTK
- 6 Configuring the output
- 7 Set the Antenna Height
- 8 Finalizing the configuration
- 9 Retrieving the collected data from the receiver
- 10 Hot Swapping the batteries and charging
- 11 System Administration using the Web Interface
- 12 Appendix
12 | P a g e
2 Shipping Case Contents
One APS-NR2 system includes the following items:
Item
Purpose
USB Cable
Configuration via USB
Four Li-Ion Batteries
Powering the APS-NR2
Battery Charger
Dual bay external battery charger via a wall plug or a cigarette lighter
USB stick
Software Programs and Manuals
Wall Charger
Charging the batteries from a wall plug while they are inside the APS-NR2
Table 2: APS-NR2 Delivery Package
The package always contains two EU power cables: One is needed for the battery
charger and one for the wall charger. The power cables of the battery charger and the
wall charger are interchangeable.
When shipped outside of continental Europe, two extra power cables matching the
requirements of the country of destination are added.
Figure 1: Shipping Contents