User's Manual
Table Of Contents
- Noise is heard
- A Phone problem may exist
- Check microphone’s proper working order
- Check routing of microphone cable
- Check microphone and contacts
- Check speaker location
- Check speaker’s proper working order
- No reception
- 1 Carphone kit
- 2 Installation Diagram
- 3 Carphone layout
- 4 Preplanned Accessory Positioning
- 5 Installing the Cradle and Phone
- 6 Trouble Shooting
- 7 Appendix
User Guide
989889789789 Rev.2 – YYYY-MM-DD
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 9 of 27
Mod. 0810 2011-07 Rev.2
1.5.2. Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
1.5.3. Wireless notice:
This product emits radio frequency energy, but the radiated output power of this device is far
below the FCC and IC frequency exposure limits. This equipment complies with FCC and IC
RF radiation exposure limits forth for an uncontrolled environment. Nevertheless, the device
should be used in such a manner that the potential for human contact with the antenna during
normal operation is minimized.
RS 850/1900
This product integrates the HE863-NAR 2G/3G module (FCC ID: RI7HE863NA, IC: 5131A-
HE863NA). The HE863-NAR module is granted with a modular approval for mobile
applications. Integration has been done meeting the following conditions:
1. At least 20cm separation distance between the antenna and any person body is
maintained at all times.
2. To comply with FCC/IC regulations limiting both maximum RF output power and
human exposure to RF radiation, the maximum antenna gain including cable loss in a
mobile only exposure condition does not exceed 4.2 dBi.
3. The HE863-NAR antenna is not co-located with any other antennas.