User's Manual
Table Of Contents
- Noise is heard
- A Phone problem may exist
- Check microphone’s proper working order
- Check routing of microphone cable
- Check microphone and contacts
- Check speaker location
- Check speaker’s proper working order
- No reception
- 1 Carphone kit
- 2 Installation Diagram
- 3 Carphone layout
- 4 Preplanned Accessory Positioning
- 5 Installing the Cradle and Phone
- 6 Trouble Shooting
- 7 Appendix
User Guide
989889789789 Rev.2 – YYYY-MM-DD
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 8 of 27
Mod. 0810 2011-07 Rev.2
1.4. Antenna Configuration
Do not operate your mobile telephone when a person is within 12 inches (30 centimeters) of
the vehicle antenna. A person or object within 12 inches (30 centimeters) of the antenna could
impair call quality and may cause the phone to operate at a higher power level than necessary
and expose that person to RF energy in excess of that established by the FCC RF Exposure
Guidelines.
1.5. FCC Notice to Users
The following statement applies to all products that have received FCC approval. Applicable
products bear the FCC logo, and/or and FCC ID in the format FCC-ID:xxxxxx on the product
label. Telit has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment. See 47
CFR Sec. 15.21.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
See 47 CFR Sec. 15.19(3).
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
1.5.1. Modification statement
Telit Communications S.p.A. has not approved any changes or modifications to this device by
the user. Any changes or modifications could void the user’s authority to operate the
equipment.