User's Guide

ATOP3.5G Product Description
80447ST10636A rev.10 – 2015-03-03
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved. Page 49 of 66
Mod. 0808 2011-07 Rev.2
In order to satisfy the essential requirements of 1999/5/EC Directive, the product is compliant with the following
standards:
RF spectrum use (R&TTE art. 3.2)
EN 301 511 V9.0.2
EN 301 908-1 V5.2.1
EN 301 908-2 V5.2.1
EN 300 440-1 v 1.6.1
EN 300 440-2 v1.4.1
EN 302 291-1 v 1.1.1
(1)
EN 302 291-2 v 1.1.1
(1)
EMC (R&TTE art. 3.1b)
EN 301 489
-
1 V1.9.2
EN 301 489-3 V1.4.1
EN 301 489-7 V1.3.1
EN 301 489-24 V1.5.1
Health & Safety (R&TTE art. 3.1a)
EN 60950
-
1:2006 + A11:2009 + A1:2010 + A12:2011 + AC:2011
EN 62311:2008
(1)
Only applicable to the product OM12030/1X0 with X as defined in section 5.
The conformity assessment procedure referred to in Article 10 and detailed in Annex IV of Directive 1999/5/EC has
been followed with the involvement of the following Notified Body:
AT4 wireless, S.A.
Parque Tecnologico de Andalucía
C/ Severo Ochoa 2
29590 Campanillas – Málaga
SPAIN
Notified Body No: 1909
Thus, the following marking is included in the product:
There is no restriction for the commercialization of this device in all the countries of the European Union.
Final product integrating this module must be assessed against essential requirements of the 1999/5/EC (R&TTE)
Directive. It should be noted that assessment does not necessarily lead to testing. Telit Communications S.p.A.
recommends carrying out the following assessments:
RF spectrum use (R&TTE art. 3.2)
It will depend on the antenna used on the final product.
EMC (R&TTE art. 3.1b) Testing
Health & Safety (R&TTE art. 3.1a) Testing