User's Guide

ME910C1 HW User Guide
1VV0301351 Rev.8 Page 94 of 100 2018-09-28
Band ME910C1-NA ME910C1-NV ME910C1-WW NE910C1-NA
FDD 1
-- -- --
FDD 2
9,01 dBi -- --
FDD 3
--- -- --
FDD 4
6,00 dBi 6,00 dBi
FDD 5
-- -- --
FDD 8
-- -- --
FDD 12
6,18 dBi --
FDD 13 -- 6,94 dBi
FDD 18 -- -- --
FDD 19 -- -- --
FDD 20 -- -- --
FDD 26 -- -- --
FDD 28 -- -- --
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre
antenne ou autre émetteur.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B) / NMB-3 (B)