User Guide

ME310G1 Hardware Design Guide
1VV0301588 Rev. 11 Page 63 of 91 2021-03-16
Recommendations for ME310G1-W1
In order to easily rework the ME310G1-W1, it is recommended to consider on the
application a 2 mm placement inhibit area around the module.
It is also suggested, as a common rule for an SMT component, to avoid having a
mechanical part of the application in direct contact with the module.
Figure 17: ME310G1-W1 Recommendations
Note: In the customer application, the region under WIRING
INHIBIT (see the figure above) must be clear from signal or ground
paths.