User Guide

ME310G1 Hardware User Guide
1VV0301588 Rev. 4 Page 60 of 77 2020-01-21
10.1.3. Recommendations for ME310G1-WW
In order to easily rework the ME310G1-WW is suggested to consider on the application
placement inhibit area around the module as specified in the below figure.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical
part of the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see
figure above) must be clear from signal or ground paths.