User Guide

ME310G1 Hardware User Guide
1VV0301588 Rev. 4 Page 59 of 77 2020-01-21
10.1.2. Recommendations for ME310G1-W1
In order to easily rework the ME310G1-W1 is suggested to consider on the application a 2
mm placement inhibit area around the module.
It is also suggested, as common rule for an SMT component, to avoid having a mechanical
part of the application in direct contact with the module.
NOTE:
In the customer application, the region under WIRING INHIBIT (see
figure above) must be clear from signal or ground paths.