User's Manual

35
1.3.4 1X EV-DO Rev B (with QOS
for handsets)
The multi-carrier version of 1xEV-DO in
which up to three carriers are supported
on the forward and reverse links; QoS
added for handsets
1.3.5 3 Carrier Rev B over 5x
Bandwidth
3 Carrier rev B over 5x bandwidth
1.3.6 Max Bandwidth Support Support calls where the AN assigns outer
carriers that are 5.16 MHz apart
1.3.7 Rev B physical layer FL
rates
Enhanced flow rates on FL
1.4 Modem (eHRPD)
1.4.1 eHRPD: eHRPD <-> 1x
handoff
Allows the mobile to move between areas
of eHRPD coverage and 1x coverage
(and vice-versa).
1.4.2 eHRPD: eHRPD <-> HRPD
handoff
When moving from 1x/HRPD to eHRPD,
AT should not send ULN. When moving
back from eHRPD to HRPD, also AT
should not send ULN.
1.5 Modem (Geran)
1.5.1 GERAN 3GPP Rel-8 Spec
compliance
GERAN compliant with Rel-8 spec
versions
1.5.2 NACC, Ext UL TBF Rel Network-Assisted Cell Selection for faster
cell reselection and Extended UL TBF
Release to extend the UL TBF and reduce
the incidence of idle activity between
packet transfer activities
1.2.3 PFC/PFI Packet Flow Context/Packet Flow
Identifier - Allows identity tagging of RLC
blocks to identify separate QoS streams at
the radio link layer
1.5.4 EDGE MSC12 Original legacy EDGE support with
Multislot Class 12 capability
1.5.5 GPRS/EDGE MSC12-EDA Extended Dynamic Allocation to permit
allocation of more than two uplink
timeslots for GPRS/EDGE
1.5.6 Enh DL RLC/MAC
Segmentation
Permits reception of MAC control
messages that exceed one radio block
capacity in length
1.5.7 Enhanced Ext UL TBF Per Ext UL TBF, with the addition that
dummy block transmission is punctured
for current saving purposes
1.5.8 2G PS handover Packet-switched equivalent of CS
handover to ensure faster cell change and
improved throughput
1.5.9 Encryption: GEA3 New packet-switched cipher algorithm
1.5.10 WCDMA/GERAN: Band
Scan – Run-time
Configurable RRC Band
Scan Order
Run-time configurable RRC band scan
order