User's Manual

xN930 M.2 Hardware User Guide
1VV0301078 Rev.6 – 2013-11-12
8.3
Power Consumption
This section lists the power consumption targets.
Typical target values at Vsys = 3.3 V
Table 27
LTE Power Consumption
M.2 Power Consumption (*) Transmit Power
LTE Use Case Band 10 dBm 23 dBm
LTE UTP, Cat. 3, 100 Mbps/50 Mbps, 20
Band 7
1068 mW
2531 mW
LTE UTP, Cat. 3, max throughput, 10 MHz
Band 17
916 mW
2394 mW
LTE Use Case Standby Power
LTE Stand-by current, DRX 1.28 s serv.
Cell only
6 mW
(*) Applicable to modules:
• LN930
• LN930-AP
Table 28
UMTS Power Consumption
M.2 Power Consumption Transmit Power
UMTS Use Case
(DC-HSDAP+ or HSDPA+)
Band 10 dBm
UMTS FTP, Cat. 24, RxDiv
(M.2 DC-HSDPA+)
Band 1 988 mW
UMTS FTP, Cat 14, QAM64
(M.2 DC-HSDPA+)
Band 1 771 mW
UMTS FTP, Cat 14, QAM64
(M.2 HSDPA+)
Band 1 813 mW
Standby Power
UMTS Stand-by current, DRX7, 16NB cells - 6 mW
Table 29
GSM Power Consumption
GSM Use Case Band Transmit Power
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 58 of 77