User's Manual
Table Of Contents
- 1 Introduction
- 2 M.2 Overview
- 3 M.2 Module Interface Details
- 3.1 USB 2.0 High-Speed – IPC Interface
- 3.2 (U)SIM Interface
- 3.3 GNSS Interface
- 3.4 System Control Interface
- 3.5 Tunable Antenna Control Interface
- 3.6 In-Device Coexistence Interface
- 3.7 Power Supply Interface
- 3.8 Trace & Debug Interface
- 3.9 Configuration Pins
- 3.10 Reserved Pins
- 3.11 No Connect Pins
- 3.12 Antenna Interface
- 4 Development Tools
- 5 Windows Software Components
- 6 Modem Configuration on Linux Based PC
- 7 Operating Environment
- 8 Power Delivery Requirements
- 9 Other Information
- 10 WWAN Card Type 3042-S3-B
- 11 Safety Recommendations
- 12 Conformity assessment issues
- 13 FCC/IC Regulatory notices
- 14 Document History
xN930 M.2 Hardware User Guide
1VV0301078 Rev.6 – 2013-11-12
Figure 11
M.2 Carrier Board
4.1.1
FlashTool
Intel Mobile Communications provides a utility program called FlashTool for
downloading a binary image into the Flash memory of the M.2 module. The USB-HS port
or USIF on the platform is used for connection to a PC via a USB cable for flashing.
FlashTool is a Win32/64 application built on top of the dynamic link library,
Download.DLL.
4.1.2
PhoneTool
PhoneTool is a development tool built on top of the so-called “production test dll,
DWDIO.dll”. PhoneTool can be used to fine tune the parameters of:
• Audio configuration and settings (if enabled on M.2 module)
• NV (Non-Volatile) memory
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 45 of 77