User's Manual
Table Of Contents
- 1 Introduction
- 2 M.2 Overview
- 3 M.2 Module Interface Details
- 3.1 USB 2.0 High-Speed – IPC Interface
- 3.2 (U)SIM Interface
- 3.3 GNSS Interface
- 3.4 System Control Interface
- 3.5 Tunable Antenna Control Interface
- 3.6 In-Device Coexistence Interface
- 3.7 Power Supply Interface
- 3.8 Trace & Debug Interface
- 3.9 Configuration Pins
- 3.10 Reserved Pins
- 3.11 No Connect Pins
- 3.12 Antenna Interface
- 4 Development Tools
- 5 Windows Software Components
- 6 Modem Configuration on Linux Based PC
- 7 Operating Environment
- 8 Power Delivery Requirements
- 9 Other Information
- 10 WWAN Card Type 3042-S3-B
- 11 Safety Recommendations
- 12 Conformity assessment issues
- 13 FCC/IC Regulatory notices
- 14 Document History
xN930 M.2 Hardware User Guide
1VV0301078 Rev.6 – 2013-11-12
GNSS General Features
• Autonomous GPS / GLONASS
• Assisted GPS Using SUPL 1.0/2.0
• MS Assisted positioning ( SET / NET Initiated )
• MS Based positioning ( SET / NET Initiated )
• SUPL 2.0 Feature Sets
• Version Negotiation
• Periodic Triggers
• Emergency Positioning
• Area Event Triggers (SET Init & NET Init)
• Application ID
• Enhanced Cell Id
• Multiple Location IDs
•
Session Info Query
• Location Transfer to 3rd Party
• Notification Verification Based on Current Location
• Location Request to another SET
A diagram of the GNSS connections on the M.2 module is shown in Figure 6. This diagram
identifies the signals between the X-GOLD™ baseband and GNSS devices along with the
USB and GNSS signals available to the host at the card interface.
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved. Page 28 of 77