User Guide

LM960 HW Design Guide
1VV0301485 Rev. 15 Page 79 of 88 2020-08-13
This device has been tested and meets applicable limits for Radio Frequency (RF) exposure.
To comply with the RF exposure requirements, this module must be installed in a host
platform that is intended to be operated in a minimum of 20 cm separation distance to the
user.
OEM/Host manufacturer responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and
Module. The final product must be reassessed against all the essential requirements of the
RED before it can be placed on the EU market. This includes reassessing the transmitter
module for compliance with the Radio and EMF essential requirements of the RED. This
module must not be incorporated into any other device or system without retesting for
compliance as multi-radio and combined equipment.
The allowable Antenna Specipication
In all cases assessment of the final product must be met against the Essential requirements
of the RE Directive Articles 3.1(a) and (b), safety and EMC respectively, as well as any
relevant Article 3.3 requirements.
1. The following antenna was verified in the conformity testing, and for compliance the
antenna shall not be modified. A separate approval is required for all other operating
configurations, including different antenna configurations.
2. If any other simultaneous transmission radio is installed in the host platform together
with this module, or above restrictions cannot be kept, a separate RF exposure
assessment and CE equipment certification is required.
Waste Electrical and Electronic Equipment (WEEE)
This symbol means that according to local laws and regulations your product
and/or its battery shall be disposed of separately from household waste. When
this product reaches its end of life, take it to a collection point designated by
local authorities. Proper recycling of your product will protect human health
and the environment.