User Guide

LM960 HW Design Guide
1VV0301485 Rev. 15 Page 32 of 88 2020-08-13
Information – PCIe bus is NOT supported
LM960 Signals That Must Be Connected
Below table specifies the LM960 signals that must be connected for debugging purposes,
even if not used by the end application:
Mandatory Signals
Pin Signal Notes
2, 24, 39, 41, 52 VBATT
4, 9, 15, 18, 21, 26, 27, 29, 34, 35, 37, 40, 43,
50
GND
38 USB_D+ If not used, connect to a test
point or an USB connector
36 USB_D- If not used, connect to a test
point or an USB connector