User Guide

LM960 HW Design Guide
1VV0301485 Rev. 3 Page 65 of 74 2018-12-14
Labelling Requirements for the Host device
The host device shall be properly labelled to identify the modules within the host device.
The certification label of the module shall be clearly visible at all times when installed in the
host device, otherwise the host device must be labelled to display the FCC ID and ISED of
the module, preceded by the words "Contains transmitter module", or the word "Contains",
or similar wording expressing the same meaning, as follows:
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules
qui s'y trouvent. L'étiquette de certification du module donné doit être posée sur l'appareil
hôte à un endroit bien en vue en tout temps. En l'absence d'étiquette, l'appareil hôte doit
porter une étiquette donnant le FCC ID et l’ISED du module, précédé des mots « Contient
un module d'émission », du mot « Contient » ou d'une formulation similaire exprimant le
même sens, comme suit :
LM960
Contains FCC ID: RI7LM960
Contains IC: 5131A-LM960
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme canadienne ICES-003.
RED Regulatory notices
RF Exposure Information (MPE)
This device has been tested and meets applicable limits for Radio Frequency (RF) exposure.
To comply with the RF exposure requirements, this module must be installed in a host
platform that is intended to be operated in a minimum of 20 cm separation distance to the
user.
OEM/Host manufacturer responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and
Module. The final product must be reassessed against all the essential requirements of the
RED before it can be placed on the EU market. This includes reassessing the transmitter
module for compliance with the Radio and EMF essential requirements of the RED. This